USB ready digital pressure sensor for recording pressures with a high speed sample rate of up to 1 kHz to a computer. The UPS-HSR is supplied with a 2m long USB cable, PC software and case. Choose a pressure range from 2.5 bar up to 5000 bar with a G1/4 or 1/4 NPT male up to 1500 bar, and AE F-250-C female up to 5000 bar.
This pressure logger can record for months at time at a slow logging rate, and when a predefined event threshold is exceeded it will record pressure at a much faster rate.
I have a small water system and I would like to monitor and record the pressure in psi and the flow in gpm in the system over an extended period of several months in order to determine the times and duration of peak demand and low pressure.
Digital interface logging pressure gauge for portable use in freshwater measurement applications, capable of measuring 0 to 200 bar sealed gauge pressure with 0.1% accuracy and connected using a G1/4 male fitting. Also includes USB, log software and traceable cal cert.
The P-Triton-P is specifically designed for monitoring water supply pressures and storing readings for long term tests.
Sealed Gauge (SG) is a type of reference pressure measured relative to a fixed pressure of approximately 1 bar absolute.
Gauge reference pressure is a pressure measured relative to atmospheric or barometric pressure. The most used pressure reference is gauge pressure which is signified by a (g) after the pressure unit (e.g. 30 psi g), and means that the pressure measured is the total pressure minus atmospheric pressure. There are two types of gauge reference […]
Sealed gauge or SG is a type of pressure reference typically used when a vented reference is not possible because of the type of sensing technology or the need to provide secondary containment overpressure protection.
Gauge reference pressure measuring devices read pressure relative to atmospheric pressure. This ensures that the pressure reading is nominally zero when the pressure on the device is released.
Four wire strain gauge type pressure transducer with a twenty millivolt full scale output with a steady 10 volt supply input.
High pressure gauge for recording pressure up to 15000 psi with internal memory for data logging
1/4″ BSP stem mounted digital pressure gauge for monitoring peak pressures up to 700 bar generated during a destructive test
Hydraulic oil pressure transmitter with an M12 electrical connector for the 4 to 20 milliamp current loop circuit and a measuring range up to 5000 psi gauge.
We are looking to integrate a pressure sensor into the bottom of a Sonde. The sensor will be used to monitor the water depth in a borehole up to a maximum of 300m.
Submersible pressure sensor to measure 10 bar pressure in pipe that is IP68 for long term submersion in sludge up to 6 metres deep.
A hydrostatic level probe typically uses pressure sensor to measure the water level. The main component of a pressure sensor is the sensing diaphragm which converts the difference in pressure between either side of the diaphragm into a measured signal. The front of the diaphragm measures the water level pressure (hydrostatic pressure) plus the barometric […]
There is a loose convention across manufacturers for designating the type of reference that a pressure sensing device has, which can be confusing if you are unfamiliar with specifying this often overlooked but critical specification parameter.
Determining whether you need gauge or absolute reference pressure is a very important to selecting the right pressure range for a pressure instrumentation.