Mechanical Stop is an internal component which protects pressure sensing components from overpressure by limiting the deflection of the diaphragm.
A mechanical stop will protect a pressure sensing device to a much higher pressure than one which relies on the natural overpressure rating of the sensing diaphragm.
Featured overpressure protected pressure measurement products
DPT200 High One Side Overload Differential Pressure Sensor - DP transmitter for measuring pressure difference between two pressure points which can tolerate up a very high overload pressure independently on either the positive or negative side port or both together at the same time.
LMK351 High Overpressure Flush Level Transmitter - Flush capacitive ceramic pressure sensor for measuring corrosive and viscous liquid level from levels 0.4 metres of water up to 200 mH2O.
Glossary of Mechanical technical terms
- Al2O3
- BFSG – Bonded Foil Strain Gauge
- Bonded Seal
- Bourdon Tube
- Burst Pressure
- Dry Cell
- Dry/Dry
- Flush Diaphragm
- Food Grade
- g – Acceleration due to Gravity
- g Effect
- Hygienic
- Hysteresis
- Isolation Diaphragm
- LVDT – Linear Variable Differential Transformer
- M10 x 1
- MTBF – Mean Time Between Failures
- Overpressure Protection
- Oxygen Service
- Piezoresistive Strain Gauges
- Stainless Steel Pressure Sensors
- Static Line Pressure
- Wet/Dry
- Wet/Wet
- Wetted Parts
- Wheatstone Bridge Strain Gauge
