SensorsONE

Pressure Sensor Calculator

Select Answer Mode
Operation
Performance Limits
Calibration Deviation
Calculate Pressure Sensor Parameters
Pressure [?]
Conversion [?]
Low Limit [?]
High Limit [?]
Output [?]
Accuracy [?]
Pressure Error [?]
Output Error [?]

Click save settings to reload page with unique web page address for bookmarking and sharing the current tool settings

✕ clear settings



Pressure sensor products

Related Tools

User Guide

This multi-function tool can be easily adapted to calculate all the main parameters required by users when setting up, configuring and calibrating the different types of pressure sensors.

Answer Modes

Operation

These answer modes will help you determine the exact input pressure or output reading for an entered measurement based on the selected pressure range and output type corresponding to your pressure sensor. Since pressure sensors are mostly scaled in bar or psi, a pressure converter is also available to convert a pressure reading to alternative units.

As an example, this is how you would set-up the tool for determining the expected output reading from a -15 to 100 psi range with a 4 to 20 mA output pressure transmitter.

Performance Limits

These choices will help you convert the manufacturers performance specification into directly relatable values for pressure and output. Manufacturer’s mainly define performance characteristics as a proportion of range, pressure or output units, and these answer modes will allow you to convert linearity, hysteresis, repeatability, stability, zero and offset errors into a pressure uncertainty, output deviation or proportion of full scale.

To demonstrate how you would use this tool to compare the manufacturer’s stated performance with actual measurements, this how you would configure the calculator to convert a 0.25% full scale accuracy to a pressure error for a -75 to +75 psi range pressure transducer.

Calibration Deviation

Use these answer modes when calibrating your pressure sensor to determine the deviation of the output from the ideal value for a particular calibration set-point, as a proportional error or in units of output or pressure.

If you were calibrating a 350 bar pressure transducer with a 0 to 33 millivolts output, this is what you would enter to determine the pressure error in millibars, if the output is 16.512 mV for a 50% calibration setpoint of 175 bar.

Pressure sensor products

Parameters

Pressure

This is the pressure which is measured by the pressure sensor, you can either enter a value to see what output to expect from a pressure sensor or you can enter the value verified by a calibration reference and compare it to the actual output to determine the calibration error.

Conversion

Pressure sensors are often scaled in bar or psi measurement units, but used to measure pressure in other units. You can use this converter to check the value of any pressure value in other units.

Low Limit

This is lowest pressure which the sensor will measure, and is used to define the lower limit of the pressure range, that also corresponds to the lowest output value.

High Limit

This is highest pressure which the sensor will measure, and is used to define the upper limit of the pressure range, that also corresponds to the highest output value.

Output

This is what the pressure sensor sends out in the form of an analogue signal or digital reading.  The output will typically vary proportionally with the measurement range as a straight line, although there will be slight deviations due to the accuracy limitations of the pressure sensor.

Accuracy

This the proportion of the pressure sensor output range which represents the amount of deviation from a perfect measurement. It is used to define the specification limits of pressure sensors on manufacturers product data sheets and brochures, and also to calculate calibration errors. Accuracy is often expressed as a percentage of full scale for pressure sensors.

Pressure Error

This is the amount of pressure deviation from a perfectly accurate measurement, and represents the scope of uncertainty in the output of the pressure sensor, expressed in pressure units.

Output Error

This is the amount of output deviation from a perfectly accurate measurement, and represents the scope of uncertainty in the output of the pressure sensor.

Pressure sensor products