An intrinsically safe all welded stainless steel gauge pressure sensor for oil pumping use to measure pressure of pumped oil over a range of 0 to 6,000 psi g from the G1/2 male process connection, and sending the corresponding 4-20mA signal through the weatherproof cable electrical connection.
This DMP 335 intrinsically safe all welded stainless steel gauge pressure sensor can be used in oil pumping to measure pressure from 0 to 6,000 pounds per square inch gauge.
The sensor is installed using a G1/2 male thread to measure the petroleum fuel, and the 4 to 20 milliamp current output is connected to signal monitoring instrumentation using the IP65 rated sealed gland and cable.
Also ATEX & IECEx intrinsically safe approval is included with this all welded gauge pressure sensor to meet the requirements of measuring oil pump pressures in designated flammable risk areas.
DMP 335 ATEX & IECEx IS All Welded Pressure Sensor
- SKU ID: s1-dmp335-91-19921
- Pressure Range: 0-6000
- Units: psi
- Range Type: Gauge (atm to +P)
- Output Signal: ATEX/IECEx IS 4-20mA, 2 wire
- Electrical Connection: IP67 cable outlet with 5m of cable
- Process Connection: G1/2 male EN837