We are currently working on a project to enable remote monitoring of water tank level. We need a stand alone remote tank monitoring system for 10 water tanks where an alarm can be transmitted once certain levels are reached, which then transmits to a remote monitoring station over the internet. Would you have a solution for this?
We would suggest the IMTG which is a low cost submersible tank level sensor and the RamBox-B which combines a signal conditioning unit with GSM mobile network communications.
IMTG Tank Level transmitter
- Part No: IMTG-G0500-1A4-AAV-A-005-000
- Pressure Datum: Gauge
- Pressure Range: 0 – 5mW
- Output: mV/V / 4-wire
- Accuracy (Combined NL&H): <±0.5% / FS (BFSL)
- Accuracy (Thermal Zero Shift): <±0.04% / FS / °C
- Electrical Connection: Vented PUR Cable
- Process Connection: Nose cone with M7x1 test port
- O Ring Seal: Viton
- Cable Length (enter in mtrs): 5 metre PUR
- Specials Code: No Special Requirements
- Diaphragm Material: Stainless Steel 1.4435 (316L)
- Housing Material: 303 Stainless Steel
- Media Temperature: -20 to +60°C non freezing
- Supply Voltage: 9 – 32V dc
RamBox Remote Asset Monitoring System Box
- Part No: RamBox-B
- Input type: mV/V, 4-wire
- Transmit Band: Quad Band EGSM 850/900/1800/1900MHz
- Protocol: TCP/IP Stack access via AT commands
- Supply Voltage: C-Cell Internal Battery
- Operating Temperature: -30°C to +75°C
- Interface: RJ45 Ethernet connection
- Description: Vent Filter
- Description: PG11 Cable Gland access for sensor