Economical corrosion resistant ceramic diaphragm pressure sensor for measuring over a 0 to 400 bar gauge pressure range and generating a 2 millivolt per volt output signal.
This configuration of the IMP is wired to monitoring & control instrumentation using a small DIN plug connector and installed using a G1/4 male DIN 3852 process fitting.
This standard version of the IMP pressure sensor has a corrosion resistant ceramic based diaphragm sensing module with thick film strain gauges and a completely dry construction with no oil filled isolation. The ceramic sensor module is sealed within the G1/4 male DIN 3852 process connector and electronic housing using a Viton elastomer O ring.
The measurement accuracy is +/-0.25% FS best straight line at room temperature, with an additional thermal zero shift error of 0.04% FS/°C and thermal span shift error of 0.015% FS/°C.
IMP Ceramic Strain Gauge Pressure Transducer
- SKU ID: s1-imp-12-17755
- Pressure Range: 0 to 400
- Units: bar
- Pressure Reference: Gauge (G)
- Output Signal: 2mV/V, 4-wire (2)
- Non-Linearity and Hysteresis: 0.25% FS (standard) (A)
- Thermal Zero Shift: 0.04% FS per °C (standard) (4)
- Thermal Span Shift: 0.015% FS per °C
- Electrical Connection: Small DIN plug (A)
- Process Connection: G1/4 male DIN 3852 (A)
- Media Exposed Seals: Viton (standard)(V)
- Special Requirements: Standard (000)