This submersible pressure transducer and display can be used by landfill site pump techs to read leachate water level above the transducer at the well head.
The outer sheath of the cable and the sensor body are made from PP-HT to withstand a low pH level contaminate groundwater in a leachate sump.
The LMK 807 transducer has a 0 to 5 psi range for measuring the level in the leachate sump and a 4 to 20 milliamp current loop output signal for running over a long cable run of 100 feet back to the SRP-N118 digital display unit.
LMK807 Submersible Leachate Pressure Transducer
- Pressure Range: 0 – 5 psi g
- Output Signal: 4-20mA, 2 wire
- Accuracy: 0.5% FS IEC 60770
- Installation Type: Submersible probe with removable nose cone
- Housing Material: PP-HT
- Diaphragm Material: Ceramic Al2O3 96%
- Media Exposed Seals: FKM
- Cable Type: PVC (70degC max)
- Cable Length: 100
- Cable Length Units: Feet (ft)
- Special Options: None
SRP-N118 Digital Display
- Display: 4 digits 9999 (N118)
- Input: 0/4-20 mA, 0/1-5V, 0/2-10V (18)
- Output: 1 x REL + 1 x AO (0/1-5V, 0/2-10V, active, non-isolated) (2B)
- Communication interface: RS-485 (1)
- Power supply: 85V – 260V AC/DC (4)
- Options: no options (001)
- Display: Red LED 4 x 20mm High, -999 to +9999 + decimal point
- Transducer Power Supply: 24 V DC +/-15% max.100 mA
- Operating Temperature: 0 – 50°C
- Case Style: Wall Mounted
- Case Dimension: 110 x 80 x 67mm (excluding cable glands)
- IP Rating: 67
- Case Material: ABS + polycarbonate (standard)