Submersible stainless steel pressure transmitter ideal for geotechnical surveying with a 19mm diameter for measuring hydrostatic water level in bore-holes.
Miniature measurement instrumentation are used in research and test applications where a small size & weight is essential to ensure the sensors can be fitted into hard to reach areas of the installation, and to reduce any affect on the outcome of the testing due to the increased mass & volume contributed by the sensors.
This small size pressure & temperature transducer has a PT100 platinum resistance thermometer and a 0 to 10 bar gauge pressure range with a radiometric output of 0.5 to 4.5 volts dc with a supply voltage of 5 volts dc.
The TPFAS pressure sensor has a small size flush diaphragm which allows the use of a smaller size G1/4 (1/4 BSP) or M10 x 1 male thread for fitting where there is limited room or access to the process measurement point.
Small diameter and short length pressure transducers with amplified voltage output.
Miniature size sensors with small size dimensions for measurements where a small diameter, short length or a low mass is required.
Need to do long term monitoring of water levels in water production wells through 3/4 inch sounding tubes
I need a submersible pressure transducer for level measurement in a small diameter pipe that is up to 30 metres deep in a dam bank.
Looking for very compact pressure sensor to be installed on M5 thread, measure DOT4 brake fluid between 1-30 bar
The chemical resistant LMK806 submersible level probe is designed for use in confined spaces with aggressive media.
19mm diameter bore hole submersible water sensor designed to measure 0-10000 mmH2O raw water level with a 4-20mA output.
MTM3000 Miniature Level Sensor specially designed for inserting down very small boreholes in wells, dams and many geophysical research applications.
Small diameter pressure sensor of lowering inside a 20mm pipe to monitor water depth 30 metres below ground level.
The ASL low cost miniature pressure transmitter, has a piezoresistive ceramic pressure sensor which is chemically inert and has very fast dynamic response.
We are searching for a transducer for to monitor water in an upland bog
1/2 inch diameter sensor for measuring both temperature and pressure in one device.
Miniature size 1/2 inch diameter stainless steel pressure sensor with an amplified 0.5 to 4.5 Vdc output. Pressure ranges start from 10 up to 400 bar.
IP68 sealed hydrostatic level transmitter with a 17mm diameter for lowering into ground water boreholes for environmental monitoring of water level.
Motorsport pressure transducer with 21mm diameter and and 24mm body length for pressure ranges from 0.5 up to 600 bar gauge or absolute. Available with millivolt and amplified voltage output signals.