I have a 3 wire pressure transducer with a 0-10 volt output, and I need to isolate supply from output so the supply ground is separate to output ground.
Electrical Connections
Choosing PVC, PUR, FEP and TPE cable types
When specifying the electrical connection for the DMP, DMK, LMP and LMK series of pressure/level transmitters you will need to choose from a selection of cable types.
Determining the Signal Cable Length of a Suspended Liquid Level Transducer
Deciding the correct length of cable for a suspended IP68 transducer is an important part of specifying, if the cable is too short it is difficult and expensive to join two cables together and make the seal liquid tight. There are two separate parts of the installation that need to be considered to determine the […]
Improve the electrical termination of vented submersible pressure sensors
Submersible cable is more expensive because it has to be reinforced to support the sensor plus its own weight in deep holes without stretching which would lead to a change in sensor position and ultimately sensor calibration. A submersible cable also has a vent tube running through it to allow gauge reference pressure sensors access […]
KL1 Cable Junction Box for Submersible Level Transmitters
Robust cable junction box for terminating vented electrical cable from a submersible level transmitter. vented to the outside air pressure.
IP65 sealing a vented gauge pressure transmitter with a DIN plug
For most general purpose applications the DIN43650 plug and socket connector is one of the most widely specified for industrial pressure transmitters.