0…40 mbar or 0…16 inH2O pressure range, 0…10 V, 0…5 V, or 1…5 V output signal pressure sensors.
A low range submersible liquid level sensor for submerging in a shallow water tank and measuring the depth over a range of 0 to 16in from the flush open face diaphragm, and sending the corresponding 4-20mA signal through the submersible cable electrical connection.
0…40 mbar, 0…16 inH2O, 0…4000 Pa, or 0…0.6 psi pressure range, 4…20 mA output signal pressure sensors.
This low range submersible water level sensor is used to monitor the depth of water collected at the bottom of a cooling tower.
DMP343 is a capable of measuring a 40 millibar negative pressure with a 4-20mA scaling over 0 to -40 mbar.
Is there a sensor that is suitable for measuring the level of a corrosive liquid up to about a foot in height, which is held in a vessel that is surrounded by a water bath?
Low range water depth sensor with a 4-20mA output, for connecting to a PLC to control a sump pump and submerging into a pit to monitor the level
Pressure to current transmitter which can be powered from a 15-24vdc and output a 4-20 mA over a pressure range of 0-40 mbar gauge.
Hydrostatic type sensor for submerging inside Genset fuel tanks to measure the level of diesel
We are looking to measure liquid level to an accuracy of 1mm over a range of around 125mm.