Low powered submersible level sensor with a 25 metre depth range, for use with a arduino controller to manage borehole drawdown and protect pump.
2.5 bar
Engine test cell fuel filter 2.5 bar differential pressure sensor with ATEX approval
Sensor to measure differential pressure across fuel filters in an engine test cell on diesel and kerosene.
2.5 bar, 35 psi Range 0-10 V, 0-5 V, 1-5 V Output Pressure Sensors
0…2.5 bar or 0…35 psi pressure range, 0…10 V, 0…5 V, or 1…5 V output signal pressure sensors.
2.5 bar, 35 psi, 2.5 kg/cm2, 250 kPa Range 4-20 mA Output Pressure Sensors
0…2.5 bar, 0…35 psi, 0…2.5 kg/cm2, or 0…250 kPa pressure range, 4…20 mA output signal pressure sensors.
2.5 bar absolute range 4 to 20 milliamps output ceramic diaphragm pressure sensor
Economical corrosion resistant ceramic diaphragm pressure sensor for measuring over a 2.5 bar absolute pressure range and generating a 4 to 20 milliamps output signal.
2.5 barg RS485 Modbus RTU interface air pressure transducer for production test automation use
A digital interface pressure transducer for production test automation use to measure pressure of air over a range of 0 to 2.5 bar g from the G1/4 male process connection, and sending the corresponding RS485 Modbus RTU communications signal through the Binder 723 connector electrical connection.
35 psi g range 0-5Vdc output air pressure sensor for leak testing use
A psi gauge pressure sensor for leak testing use to measure pressure of air over a range of 0 to 35 psi g from the G1/4 male process connection, and sending the corresponding 0-5Vdc signal through the DIN plug electrical connection.
25m borehole submersible pump level indicator and control switch with level sensor
I am hoping to use a borehole where the pump is about 25m below the surface. I would like the pump to operate automatically by switching on when the water has returned to about 14m below ground level and off at about 20m below the ground.
2.5 bar g pressure transducer with 0 to 5 volts dc output
5 volt output pressure transducer for use on dry gas with a 0 to 2.5 bar gauge pressure range, 3 metre length of signal cable and G1/4 male fitting.